NXP Semiconductors


Select site:

English

TDF8599

Selection guide

Datasheet

TDF8599
(Product Specification)
13-Nov-08, 52 pages, 318 kB

Download all documentation

I2C-bus controlled dual channel 43 W/2 Ohm single channel 85 W/1 Ohm class-D power amplifier with load diagnostics

General description
Features
Products/packages
Chemical content
Pricing/ordering/availability
Samples
Applications
Block diagrams/pinning
Design support
Parametrics/similar products
Print/email

General description

The TDF8599 is a dual Bridge-Tied Load (BTL) car audio amplifier comprising an NDMOST-NDMOST output stage based on SOI BCDMOS technology. Low dissipation enables the TDF8599 high-efficiency, class-D amplifier to be used with a smaller heat sink than those normally used with standard class-AB amplifiers.

The TDF8599 can operate in either non-I2C-bus mode or I2C-bus mode. When in I2C-bus mode, DC load detection results and fault conditions can be easily read back from the device. Up to five I2C-bus addresses can be selected when an external resistor is connected to pin ADS.

When pin ADS is short circuited to ground, the TDF8599 operates in non-I2C-bus mode. Switching between Operating mode and Mute mode in non-I2C-bus mode is only possible using pins EN and SEL_MUTE.

Features

  • High-efficiency
  • Low quiescent current
  • Operating voltage from 8 V to 18 V
  • Two 4 Ohm/2 Ohm capable BTL channels or one 1 Ohm capable BTL channel
  • Differential inputs
  • Supports I2C-bus mode with five I2C-bus addresses or non-I2C-bus mode operation
  • Clip detect
  • Independent short circuit protection for each channel
  • Advanced short circuit protection for load, GND and supply
  • Load dump protection
  • Thermal foldback and thermal protection
  • DC offset protection
  • Selectable AD or BD modulation
  • Parallel channel mode for high current drive capability
  • Advanced clocking:
    • Switchable oscillator clock source: internal (master) or external (slave)
    • Spread spectrum mode
    • Phase staggering
    • Frequency hopping
  • No 'pop noise' caused by DC output offset voltage
  • I2C-bus mode:
    • DC load detection
    • AC load detection
    • Thermal pre-warning diagnostic level setting
    • Identification of activated protections or warnings
    • Selectable diagnostic information available using pin DIAG
  • Qualified in accordance with AEC-Q100

Products/packages

Type numberNorth American Type numberOrdering code (12NC)Product statusPackagePackingMarkingChemical contentLeadfree conversion date
TDF8599TD/N29352 870 28518Samples availableSOT938-1
(HSOP36)
Reel Dry Pack, SMD, 13"Standard MarkingTDF8599TD/N2
TDF8599TD/N29352 870 28512Samples availableSOT938-1
(HSOP36)
Tube Dry PackStandard MarkingTDF8599TD/N2
TDF8599TH/N29352 867 82518Volume productionSOT851-2
(HSOP36)
Reel Dry Pack, SMD, 13"Standard MarkingTDF8599TH/N2
TDF8599TH/N29352 867 82512Volume productionSOT851-2
(HSOP36)
Tube Dry PackStandard MarkingTDF8599TH/N2
TDF8599TH/N2/S4809352 878 18518Volume productionSOT851-2
(HSOP36)
Reel Dry Pack, SMD, 13"Standard MarkingTDF8599TH/N2/S480

Pricing/ordering/availability

Type numberOrdering code(12NC)Indicative price/unit($)RegionDistributorIn stockOrder quantityInventory dateBuy onlineSamples
TDF8599TD/N29352 870 28518        not available
TDF8599TD/N29352 870 28512        not available
TDF8599TH/N29352 867 82518        not available
TDF8599TH/N29352 867 82512        not available
TDF8599TH/N2/S4809352 878 18518        not available

Parametrics/similar products

Type numberPackageREMARKSSupply
voltage(V)
RMS power(W)Gain(dB)Channel
separation(dB)
Channel
config.
Car
audio
TDF8599TD/N2SOT938-1
(HSOP36)
Diagnostic182 x 26 (43)2668 BTL stereo Class Dyes
TDF8599TH/N2SOT851-2
(HSOP36)
Diagnostic182 x 26 (43)2668 BTL stereo Class Dyes
TDF8599TH/N2/S480SOT851-2
(HSOP36)
Diagnostic182 x 26 (43)2668 BTL stereo Class Dyes


Similar products
TDF8599 links to the similar products page containing an overview of products that are similar in function or related to the type number(s) as listed on this page. The similar products page includes products from the same catalog tree(s), relevant selection guides and products from the same functional category.

Disclaimer

The information published on product information pages of the www.nxp.com or www.semiconductors.com websites is an extract from product data sheets and is for information purposes only. For detailed information please check the most recent version of the relevant product data sheet as published on these websites. In the event of any conflict between product information pages and data sheets or deviations from information provided in the product data sheets on these product information pages, the information provided in the product data sheets shall prevail.


The product status of the product(s) described in the product data sheet may have changed since publication of the data sheet and therefore information in datasheets on product status may be outdated. The latest information on product status is published on the product information pages of the above-mentioned websites.


As from October 1st, 2006 Philips Semiconductors has a new trade name - NXP Semiconductors, which will be used in future data sheets together with new contact details. In data sheets where the previous Philips references remain, please use the new links as shown below.


http://www.philips.semiconductors.com use http://www.nxp.com
http://www.semiconductors.philips.com use http://www.nxp.com (Internet)
sales.addresses@www.semiconductors.philips.com use salesaddresses@nxp.com (e-mail)

The copyright notice at the bottom of each page (or elsewhere in the document, depending on the version)
- © Koninklijke Philips Electronics N.V. (year). All rights reserved -
is replaced with:
- © NXP B.V. (year). All rights reserved.-


If you have any questions related to the data sheet, please contact our nearest sales office via e-mail or phone (details via salesaddresses@nxp.com). Thank you for your cooperation and understanding.